Witbot GT2560 Controller Board With USB Cable With A4988 Compatible StepStick Stepper Motor Diver for 3D Printer
Product Features
- The volume occupied by smaller, more convenient connections, higher stability. Set on Ultimaker and Arduino mega2560 function on a motherboard, in terms of both hardware and software perfectly replace the Arduino Mega2560 + Ultimaker Shield combinations.
- With LCD / SD card expansion interface, can link LCD screen and SD card expansion board for offline printing (supported LCD2004 and LCD12864)
- Using ATmega2560 as the main chip, with the use of high-performance USB chip FTDIFT232RQ
- The main circuit adopts SMD fuse, power supply port for reverse protection diode, 5V USB power interface with the recoverable fuse protection 500MA
- Support A4988 stepper motor drive.
Product Description
specifications:
GT2560 integrated Arduino nega2560 + Ultimaker and Arduino ga2560Me + Ramps1.4 all the features of the composition of body type small, compact arrangement of compon
Customer Reviews
Similar Posts
BALITENSEN KFB2.0 Controller Board for Reprap Mendel Prusa I3 Kossel 3D Printer
Spread the love Product FeaturesThe power buck chip using XL1509 chip, high efficiency, stability. short circuit protection, 150KHz fixed switching... 
JGAURORA 3D Printer Kit 1pc of Mainboard Controller Panel for RepRap Arduino Mega2560+ Ramps 1.4
Spread the love Product Features1pc of PCB for 3D Printer Kit RepRap Prusa I3 MainboardAccept 24V power supply inputMega2560+ Ramps... 
KINGPRINT Rumba 3D Printer Control Board with USB Cable for 3D Printer
Spread the love Product FeaturesIntegrated design, installation is simple; Using arduino IDE as the development of software, firmware upgrades, configuration... 