Adjustable 60 WS2812 LED Ring #3DPrinting #3DThursday

Spread the love

Cff1a20d49b7c4049b8fccc2cf3ed3a4 preview featured 1

247generator shared this project on Thingiverse!

Got a set of 4 quarters (15 LEDs each) of a circle of WS2812 (did not see any WS2812B at the time) LEDs off fleaBay and wanted a circular frame to hold them together. I whipped this up from scratch in OpenSCAD because I know just enough to fumble my way to somewhat working code. I cut out a square space at the back so that they can be soldered up without it interfering with them sitting flat. I have created a clock face and I’m controlling the LEDs with an Arduino Nano, but getting them into a circular ring was the first step, and may be all you need.

See more!

Similar Posts
Volkswagen toolmaking opens advanced 3D printing center, plans to mass produce parts in 2-3 years
Spread the loveDec 11, 2018 | By Thomas German automaker Volkswagen’s toolmaking unit has just announced that it is opening...
HQ Visit: MakerBot launches Method performance 3D printer
Spread the loveToday, two years after the launch of the Replicator +, American desktop 3D printer manufacturer and Stratasys subsidiary...
Siemens opens £24 million Advanced Manufacturing at the University of Nottingham
Spread the loveSiemens, Europe’s largest industrial manufacturing company, has opened a £24 million research facility at the University of Nottingham...

There are no comments yet, add one below.

Leave a Reply


Name (required)

Email (required)

Website

%d bloggers like this: