Iverntech StepStick A4988 Stepper Motor Driver Module with Heat Sink for Reprap 3D Printer Controller Ramps1.4

Iverntech StepStick A4988 Stepper Motor Driver Module with Heat Sink for Reprap 3D Printer Controller Ramps1.4

Spread the love

Product Features

  • A4988 driver board widely used in 3D printers with one extruder and small CNC machines
  • Simple step and direction control interface
  • Five model resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step
  • Thermal protection, over-current protection, ground fault protection
  • Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor's rated voltage toachieve higher step rates
(as of 12/11/2018 04:21 UTC - Details)

Product Description

Features:

* Automatic current decay mode detection / selection

* Mixed with slow current decay modes

* Synchronous rectification for low power dissipation

*



Customer Reviews

Similar Posts
AUS TMC2130 Stepper Motor Driver Module Heat Sink Screwdriver Kit For 3D Printer Parts
AUS TMC2130 Stepper Motor Driver Module Heat Sink Screwdriver Kit For 3D Printer Parts
Spread the love Product FeaturesTwo-phase stepper motor single-phase current is 1.2A (peak 2.5A), motor operating current is adjustable.Support two control...
APC220 Radio Communication Module/With This Module, You Can Build Wireless Projects In An Easy Way
APC220 Radio Communication Module/With This Module, You Can Build Wireless Projects In An Easy Way
Spread the love Product FeaturesTransmit distance up to 1000m (line of sight) @9600 bps256 bytes data buffer/High sensitivity (-112dbbm @9600...
HiLetgo A4988 Stepstick Stepper Motor Driver Module + Heat Sink for 3d Printer Reprap Compatible to Arduino
HiLetgo A4988 Stepstick Stepper Motor Driver Module + Heat Sink for 3d Printer Reprap Compatible to Arduino
Spread the love Product FeaturesSimple step and direction control interface,Take anti-static measures before you use the A4988 modules in case...
%d bloggers like this: